Learning Labs , 5 labs

Motion & Gravity

Launch a ball with air drag, shake a chain of masses and springs, tune a machine's isolator, stop a car on wet roads, snow or ice and plan a transfer between two orbits. Every lab here runs live on a reviewed model, with challenges the model scores.

Start from your question

What are you working out?

The labs

All 5 motion & gravity labs

Motion & gravity

Coupled Spring Mass Modal Analysis

A chain of 2 to 4 masses joined by springs and dampers, with a fixed or free right end. The model finds the natural frequencies and mode shapes by the Jacobi method, simulates the free or forced motion step by step (classic Runge-Kutta, 200 steps) with its kinetic, potential and total energy, and computes the steady response to a shaking force across 40 frequencies, with five scored challenges. For learning vibrations and numerical methods.

Motion & gravity

Orbital Transfer Planner

Plans an orbital transfer between two circular, coplanar orbits around the Earth, Mars or the Sun: the Hohmann or bi-elliptic burns, the total delta-v and the largest burn, the transfer time, the phase angle the target must lead by, the miss at arrival after a chosen wait, the next launch window and the synodic period, both routes compared, 181 animation frames positioned by Kepler's equation (six fixed Newton steps with a rigorous error bound), the conic shapes and the burn table; refuses inputs out of range plainly, and scores five challenges. For learning orbital mechanics and transfer planning.

Motion & gravity

Projectile Optimization Laboratory

Launches a ball under constant gravity with no, linear or quadratic air drag and follows it in 121 RK4 frames: range, flight time, highest point, impact speed and angle, and whether it hits a target you place. A 21-angle search, each angle its own trajectory, finds the longest-range angle and the angles that hit, with closed-form no-drag and linear-drag checks and five scored challenges. For learning numerical integration and projectile motion.

Motion & gravity

Vehicle Braking Dynamics Lab

Simulates a two-axle car braking in a straight line towards a hazard over up to four road zones (dry asphalt, wet asphalt, snow, ice), with the reaction and brake build-up time, load transfer to the front axle, an exponential slip-friction curve per surface, quasi-static wheels that roll, lock (ABS off) or are held at an ABS slip target (ABS on), and aerodynamic drag. Each road segment is an exact closed form, so the stopping distance and time, the speed at the hazard, the share of the stop with each axle at its limit, the ideal brake bias and a comparison car (ABS switched or the best possible braking) are exact; 161 animation frames, the braking segments and the friction curves follow. Refuses invalid inputs plainly, warns of a rear lock, and scores five challenges. For learning vehicle braking dynamics.

Motion & gravity

Vibration Isolation Tuner

Tunes a machine's isolator on a vibrating floor: one stage or two, a viscous damper or a rubber mount; the transmissibility at the floor's frequency as a ratio, a percent and decibels, with the machine's amplitude, phase lag and the force passed on; the response curve from 0.25 to 250 Hz for both damping models and two stages; the exact start-up (resonance) peak and the least damping that meets a peak limit; the exact worst case in a target band; the static sag; the best design in closed form and a 17 x 17 design map; the two-stage natural frequencies; and 96 frames of the steady-state motion. Refuses inputs out of range plainly, warns when a limit is broken or the mount amplifies, and scores five challenges. For learning vibration isolation, damping trade-offs and frequency response.

Results are informational and not professional advice. See our Terms of Use. Calculations powered by SpreadsheetWeb.
About · Privacy · Terms